Air quality in Albertville, Auvergne-Rhône-Alpes, France today

Update date
Last updated: 2026-02-10T15:00:00+00:00
[Advertisement 1]

Mr. Duck’s Air Quality Score

Mr. Duck – Good air today

Good air today for Albertville, Auvergne-Rhône-Alpes, France

⚠️ This website is currently under active development. Some data may be incomplete or temporarily inaccurate. For health-critical decisions, please verify information through official government or environmental sources.
Categories follow US EPA AQI breakpoints for PM (estimate from latest valid measurements; this project does not compute EPA NowCast/24-hour AQI yet).

This friendly indicator summarizes the latest city readings. For health guidance, please see: EPA AirNow or WHO.

Air quality today

The air quality in Albertville today is classified as Good. The primary pollutant measured is PM2.5 (fine particles).

Four valid measurements were recorded, showing a PM2.5 concentration of 4.8 µg/m³ and a PM10 level of 13.3 µg/m³. Data is shown via OpenAQ. This page is informational; for health guidance, use official sources such as EPA AirNow or WHO.

Latest sensor values

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

Good
PM25
4.8
µg/m³
Good
PM10
13.3
µg/m³
Measured
O3
48.5
µg/m³
Measured
NO2
14.6
µg/m³
[Advertisement 2]

What the data includes

The dataset for Albertville contains a single monitoring station that reports five pollutants: nitrogen monoxide (NO), nitrogen dioxide (NO2), ozone (O3), particulate matter ≤ 10 µm (PM10) and particulate matter ≤ 2.5 µm (PM2.5). The most recent measurement timestamps are fairly current for four of the gases, all recorded on 2026‑02‑10 at 15:00 UTC, while the NO value is older, last updated on 2024‑03‑11 at 09:00 UTC. Because there is only one row in the source table, the coverage is limited to this lone location and does not capture spatial variation across the city.

All reported concentrations are identical to their minimum, median and maximum values, indicating that each pollutant has a single recorded reading rather than a range of observations. NO registers 4.0 µg/m³, NO2 14.6 µg/m³, O3 48.5 µg/m³, PM10 13.3 µg/m³ and PM2.5 4.8 µg/m³. The percentiles (p10 and p90) match these same numbers, confirming the absence of multiple data points for any pollutant.

Because the dataset consists of only one recent entry per pollutant (except NO), it provides a snapshot rather than a continuous record. Consequently, while the figures give an immediate sense of current air quality at the monitoring site, they do not reflect temporal trends or differences across neighborhoods in Albertville. Users should keep in mind that conditions can vary elsewhere and over time, and additional measurements would be needed for a fuller picture.

Learn more about sources and filtering: About the data.

Trusted references: WHO (Air pollution) · US EPA AirNow · European Environment Agency (Air)

Latest sensor values (bars)

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

PM25 4.8 µg/m³ PM10 13.3 µg/m³ O3 48.5 µg/m³ NO2 14.6 µg/m³
[Advertisement 3]

Data notes

The data shown for Albertville reflects four valid measurements and was updated within three days, with the latest refresh recorded at 2026‑02‑10T15:00:00+00:00. This snapshot provides a current view of air quality across the city, but conditions can differ by specific neighbourhoods and change throughout the day, so values may not represent every location or moment in Albertville.

OpenAQ station rows

StationParameterValueUnitLast updated
Albertvilleno4.0µg/m³2024-03-11 09:00 UTC
Albertvilleno214.6µg/m³2026-02-10 15:00 UTC
Albertvilleo348.5µg/m³2026-02-10 15:00 UTC
Albertvillepm1013.3µg/m³2026-02-10 15:00 UTC
Albertvillepm254.8µg/m³2026-02-10 15:00 UTC