Air quality in District of Tuggeranong, Australia today

Mr. Duck’s Air Quality Score

Good air today for District of Tuggeranong, Australia

⚠️ This website is currently under active development. Some data may be incomplete or temporarily inaccurate. For health-critical decisions, please verify information through official government or environmental sources.

Categories follow US EPA AQI breakpoints for PM (estimate from latest valid measurements; this project does not compute EPA NowCast/24-hour AQI yet).

This friendly indicator summarizes the latest city readings. For health guidance, please see: EPA AirNow or WHO.

Air quality today

The air quality in the District of Tuggeranong is currently classified as Good. The primary pollutant measured is PM2.5. Recent readings show a PM2.5 concentration of 7.54 µg/m³ and a PM10 concentration of 8.01 µg/m³. Fine particles (PM2.5) and coarse particles (PM10) are the two metrics reported for today. The reported values are based on the ten valid measurements collected for today. Having ten valid measurements ensures a reliable snapshot of today's particulate levels. Both PM2.5 and PM10 values are presented to give a complete picture of particulate matter in the air. The values are expressed in micrograms per cubic metre, the standard unit for air quality reporting. These figures are derived from the OpenAQ network, which aggregates data from monitoring stations.

Data is shown via OpenAQ. This page is informational; for health guidance, use official sources such as EPA AirNow or WHO.

Latest sensor values

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

What the data includes

The dataset for the District of Tuggeranong contains measurements for carbon monoxide, nitrogen dioxide, ozone, particulate matter 1, particulate matter 10, particulate matter 2.5, relative humidity and temperature; the sensor type UM003 is listed but no values are reported for it. In total eleven rows of observations are drawn from two monitoring stations, Monash and Kambah. All of the latest timestamps fall on 2026‑02‑10, ranging from 20:00 to 22:00 UTC, and each pollutant is marked as having been updated within the past three days, indicating that the most recent data are fairly fresh.

The numeric spread differs across pollutants. Particulate matter 10 varies from a low of about 3.38 µg/m³ to a high of 8.01 µg/m³, with a median near 5.70 µg/m³, while particulate matter 2.5 is clustered tighter between 6.5 and 7.54 µg/m³, median 7.02 µg/m³. Carbon monoxide, nitrogen dioxide and ozone each show a single reported value—0.19 ppm, 0.006 ppm and 0.014 ppm respectively—reflecting the limited sampling at the Monash site. Particulate matter 1, relative humidity and temperature are all recorded at the Kambah station, with values of 5.25 µg/m³, 56.90 % and 21.59 °C respectively, each unchanged across the recent observations.

Because only two stations contribute data, the spatial coverage for Tuggeranong is modest and the dataset does not capture the full variability that may exist across the district. While the timestamps are recent, the small number of measurement points means that conditions can differ by location and time beyond what is shown here.

Learn more about sources and filtering: About the data.

Trusted references: WHO (Air pollution) · US EPA AirNow · European Environment Agency (Air)

Latest sensor values (bars)

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

Data notes

This snapshot is based on 10 valid measurements and was updated within 3 days, with the latest data timestamped 2026-02-10T22:00:00+00:00. Air quality can vary by location and time within the city, so conditions at specific sites may differ from this summary. The dataset meets standard quality checks.

OpenAQ station rows