Air quality in Multan Saddar Tehsil, Punjab, Pakistan today

Mr. Duck’s Air Quality Score

Unhealthy air today for Multan Saddar Tehsil, Punjab, Pakistan

⚠️ This website is currently under active development. Some data may be incomplete or temporarily inaccurate. For health-critical decisions, please verify information through official government or environmental sources.

Categories follow US EPA AQI breakpoints for PM (estimate from latest valid measurements; this project does not compute EPA NowCast/24-hour AQI yet).

This friendly indicator summarizes the latest city readings. For health guidance, please see: EPA AirNow or WHO.

Air quality today

The air quality today in Multan Saddar Tehsil is classified as Unhealthy. The primary pollutant identified is PM2.5, with a measured concentration of 62.6 µg/m³ based on ten valid observations reported through OpenAQ.

Data from the same set show no reference value for PM10, and the measurement count remains at ten samples. This page is informational; for health guidance, use official sources such as EPA AirNow or WHO.

Latest sensor values

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

What the data includes

The air‑quality record for Multan Saddar Tehsil draws on three monitoring stations that each report five parameters: PM1, PM2.5, relative humidity, temperature and the particle count UM003. All of the latest readings were uploaded on 2026-02-10 at 22:00 UTC, so the data are fresh within the past week for every pollutant.

PM1 values range from about 30 µg/m³ up to a maximum of 39.40 µg/m³, with a median near 37.59 µg/m³. PM2.5 shows a broader spread, falling as low as 44.39 µg/m³ and climbing to 62.61 µg/m³; the typical (median) concentration is 61.89 µg/m³. Relative humidity varies between roughly 38.9 % and 60.25 %, centering on a median of 54.75 %. Temperature readings are the most variable, with the lowest observed at 17.43 °C and the highest at 35.43 °C; the median temperature sits close to 17.77 °C, indicating that many measurements were taken during cooler periods. The UM003 particle count spans from about 1 989 particles/cm³ to a peak of 2 774 particles/cm³, with a median of 2 708 particles/cm³.

Two practical observations emerge from these figures. First, the three stations provide complete coverage across all five pollutants, but the number of rows (15) means each sensor contributes only a handful of recent points, limiting spatial detail. Second, while PM1 and relative humidity show relatively tight ranges, PM2.5 and temperature exhibit wider spreads, suggesting that conditions can differ noticeably across the tehsil at any given moment. Because the dataset is limited to three sites and a single recent timestamp per pollutant, it captures only a snapshot; actual air quality may vary by location and time throughout Multan Saddar Tehsil.

Learn more about sources and filtering: About the data.

Trusted references: WHO (Air pollution) · US EPA AirNow · European Environment Agency (Air)

Latest sensor values (bars)

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

Data notes

The data shown for Multan Saddar Tehsil is based on ten valid measurements and was refreshed recently, with the latest update recorded at 2026‑02‑10T22:00:00+00:00 (Updated within 3 days). This snapshot reflects conditions at the time of sampling; air quality can differ across neighborhoods and change throughout the day, so values may not represent every location or moment in the city.

OpenAQ station rows