Air quality in Scanzorosciate, Lombardy, Italy today

Mr. Duck’s Air Quality Score

Moderate air today for Scanzorosciate, Lombardy, Italy

⚠️ This website is currently under active development. Some data may be incomplete or temporarily inaccurate. For health-critical decisions, please verify information through official government or environmental sources.

Categories follow US EPA AQI breakpoints for PM (estimate from latest valid measurements; this project does not compute EPA NowCast/24-hour AQI yet).

This friendly indicator summarizes the latest city readings. For health guidance, please see: EPA AirNow or WHO.

Air quality today

The air quality today in Scanzorosciate is classified as Moderate. The primary pollutant identified is PM2.5 (fine particles). Measurements show a PM2.5 concentration of 26.14 µg/m³ based on five valid observations recorded by OpenAQ.

This assessment reflects the current monitoring data without additional interpretation. This page is informational; for health guidance, use official sources such as EPA AirNow or WHO.

Latest sensor values

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

What the data includes

Scanzorosciate’s open‑air quality feed contains six distinct measurements collected from a single monitoring location: PM1, PM10, PM2.5, relative humidity, temperature and the particle count UM003. The dataset therefore comprises six rows – one for each pollutant – all reported by the same station in Lombardy.

The most recent data points are very fresh for five of the six variables, with the last update recorded on 2026‑02‑10 at 21:00 UTC for PM1 (15.645 µg/m³), PM2.5 (26.138 µg/m³), relative humidity (62.764 %), temperature (12.901 °C) and UM003 (3 347.60 particles/cm³). The only older entry is the PM10 value, which dates back to 2024‑08‑05 at 11:00 UTC and shows a concentration of 63.428 µg/m³. Because all other pollutants share the same timestamp, the dataset gives a coherent snapshot of conditions at that moment, while the PM10 reading reflects an earlier measurement.

Across the six parameters the recorded values are singletons – each pollutant has one minimum, median and maximum that are identical. This means there is no observed spread within the current data; the reported figure represents both the typical and extreme value for the limited sampling period. The uniformity of timestamps (aside from PM10) indicates that most sensors have been updated very recently, whereas the older PM10 record suggests a gap in continuous monitoring for that specific metric.

Overall, Scanzorosciate’s air‑quality profile is based on one active station providing up‑to‑date information for five pollutants and an out‑of‑date reading for PM10. Users should keep in mind that conditions can differ across the city and over time, especially given the single‑point coverage and the lack of recent PM10 data.

Learn more about sources and filtering: About the data.

Trusted references: WHO (Air pollution) · US EPA AirNow · European Environment Agency (Air)

Latest sensor values (bars)

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

Data notes

The data shown for Scanzorosciate is based on five valid measurements and was refreshed recently, being Updated within 3 days (last update: 2026‑02‑10T21:00:00+00:00). This snapshot reflects the conditions recorded at that time; air quality can vary across different neighbourhoods and moments throughout the city.

OpenAQ station rows