Air quality in Spinadesco, Lombardy, Italy today

Update date
Last updated: 2026-02-08T19:00:00+00:00
[Advertisement 1]

Mr. Duck’s Air Quality Score

Mr. Duck – Unhealthy for sensitive groups

Unhealthy for sensitive groups for Spinadesco, Lombardy, Italy

⚠️ This website is currently under active development. Some data may be incomplete or temporarily inaccurate. For health-critical decisions, please verify information through official government or environmental sources.
Categories follow US EPA AQI breakpoints for PM (estimate from latest valid measurements; this project does not compute EPA NowCast/24-hour AQI yet).

This friendly indicator summarizes the latest city readings. For health guidance, please see: EPA AirNow or WHO.

Air quality today

The air quality in Spinadesco today falls within the USG category. The primary pollutant identified is PM2.5, with a measured concentration of 42.6 µg/m³, while PM10 registers at 49.2 µg/m³ based on four valid observations.

Data are shown via OpenAQ and reflect the current monitoring results for this location. This page is informational; for health guidance, use official sources such as EPA AirNow or WHO.

Latest sensor values

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

Unhealthy for Sensitive Groups
PM25
42.6
µg/m³
Good
PM10
49.2
µg/m³
Measured
O3
26.6
µg/m³
Measured
NO2
24.4
µg/m³
[Advertisement 2]

What the data includes

The air‑quality record for Spinadesco draws on a single monitoring location that reports four key pollutants: nitrogen dioxide (NO₂) at 24.35 µg/m³, ozone (O₃) at 26.63 µg/m³, particulate matter 10 µm or less (PM10) at 49.2 µg/m³ and fine particulate matter 2.5 µm or less (PM2.5) at 42.6 µg/m³. All four measurements were last updated on 2026‑02‑08 19:00 UTC, which falls within the “updated within 7 days” freshness category used by OpenAQ.

Because only one station contributes data for each pollutant, the dataset does not provide a range of values across different parts of the city; the minimum, median and maximum are identical for every compound. This means the reported figures represent a single snapshot rather than a distribution, limiting insight into spatial variability or temporal trends. Nevertheless, the uniform timestamp indicates that the most recent observations are current as of early February 2026, offering a timely picture of conditions at that moment.

In practical terms, the available data set is very narrow: there are four pollutant‑specific rows and no older or unknown timestamps to compare against. Users should keep in mind that air quality can differ across neighborhoods and over time, so these numbers capture only one location’s state on a specific date and hour.

Learn more about sources and filtering: About the data.

Trusted references: WHO (Air pollution) · US EPA AirNow · European Environment Agency (Air)

Latest sensor values (bars)

PM categories follow US EPA AQI breakpoints, shown here as an estimate derived from the latest valid measurements (this project does not compute EPA NowCast/24-hour AQI yet).

PM25 42.6 µg/m³ PM10 49.2 µg/m³ O3 26.6 µg/m³ NO2 24.4 µg/m³
[Advertisement 3]

Data notes

The data shown for Spinadesco reflects four valid measurements and was refreshed recently, with the latest update recorded on 2026‑02‑08 at 19:00 UTC, meaning it is updated within three days. This snapshot provides a current view of ambient conditions, but air quality can differ across neighborhoods and change throughout the day, so values may not represent every location or moment in the city.

OpenAQ station rows

StationParameterValueUnitLast updated
SPINADESCOno224.3532829µg/m³2026-02-08 19:00 UTC
SPINADESCOo326.62573µg/m³2026-02-08 19:00 UTC
SPINADESCOpm1049.2µg/m³2026-02-08 19:00 UTC
SPINADESCOpm2542.6µg/m³2026-02-08 19:00 UTC